Figure 3-93 Displaying Spanning Tree Port Information - SMC Networks 6128PL2 - annexe 2 Management Manual

3
Configuring the Switch
the amount of frame flooding required to rebuild address tables during
reconfiguration events, does not cause the spanning tree to reconfigure when the
interface changes state, and also overcomes other STA-related timeout problems.
However, remember that Edge Port should only be enabled for ports connected to
an end-node device.
• Admin Link Type – The link type attached to this interface.
- Point-to-Point – A connection to exactly one other bridge.
- Shared – A connection to two or more bridges.
- Auto – The switch automatically determines if the interface is attached to a
point-to-point link or to shared media.
Web – Click Spanning Tree, STA, Port Information or STA Trunk Information.
CLI – This example shows the STA attributes for port 5.
Console#show spanning-tree ethernet 1/5
Eth 1/ 5 information
--------------------------------------------------------------
Admin status:
Role:
State:
Path cost:
Priority:
Designated cost:
Designated port
Designated root:
Designated bridge:
Fast forwarding:
Forward transitions:
Admin edge port:
Oper edge port:
Admin Link type:
Oper Link type:
Spanning Tree Status:
Console#
3-154

Figure 3-93 Displaying Spanning Tree Port Information

enabled
disable
discarding
10000
128
0
: 128.5
32768.0012CF0B0D00
32768.0012CF0B0D00
disabled
0
disabled
disabled
auto
point-to-point
enabled
4-217