Basic Operation; Mode Display; Switching The Monitor On / Off; Mute Function - VDO MR6000 Owner's Manual And Mounting Instructions

Basic operation

• If a name has been entered, this appears in SUB
mode. If no name has been entered, the dis-
play shows "----------". The procedure for enter-
ing data is explained under "Entering titles"
in the section "Other functions".
• Special characters in CD and TV names or sta-
tion abbreviations in RDS are not shown on the
front display. In this case, the corresponding
positions remain empty.
• If no RDS time data is received, "CT --:--" ap-
pears on the display.

Mode display

Extended unit:
Press the TITLE button i to recall the title
list. Station designations, etc. can be found in
the title list stored under preset buttons c 1
to 6.
The programme names of the presets are displayed in RDS
operating mode.
For further information see "Display of title list".
Opening and rotating the dis-
play
Note:
• Do not place any objects on the open display.
• Do not allow any objects to fall onto the mov-
ing part.
• The display must not be exposed to impacts.
1. Press the OPEN button a to extend the LCD
colour f display.
The LCD colour display is retracted again if left in the
horizontal position for at least 10 seconds.
2. Fold the LCD colour display upwards and set
to the optimal viewing angle.
The display is activated as soon as the LCD
colour display is in the vertical position. Si-
multaneously, the display 4 on the unit front
is switched off.
18
CAUTION
Only rotate the display when it is fully open.
When setting the display angle, ensure that
you do not trap your fingers in the operating
panel or in the instrument panel of the vehicle.
3. Turn the unit horizontally to the detent posi-
tion to retract the LCD colour display.

Switching the monitor on / off

Each time the DISP button b is actuated, the
monitor is switched on or off.
If a button is pressed during operational readiness, the screen
is switched on.

Mute function

The loudspeakers are alternately switched be-
tween mute and on by pressing the MUTE but-
ton d.
If mute function is active, "MUTE" appears on
the display.