VDO MR6000 Owner's Manual And Mounting Instructions page 19

Sound processor
The unit is equipped with a sound processor
with 3 pre-programmed tone types (sounds).
Set the sound as desired.
* The initial factory setting is "Z-EHCR OFF".
If a tone type is selected (1-3), "Z-EHCR" illu-
minates on the display.
• "Z-EHCR 1" (tone type 1):
Setting for increasing bass.
• "Z-EHCR 2" (tone type 2):
Setting for increasing treble.
• "Z-EHCR 3" (tone type 3):
Setting for increasing bass and
treble.
• "Z-EHCR OFF" (sound processor off):
Neither bass nor treble are in-
creased via the Z enhancer.
Retracted unit:
Each time the SOUND button 9 is actuated,
the tone type is changed in the following se-
quence:
"Z-EHCR 1" –> "Z-EHCR 2" –> "Z-EHCR 3" –>
"Z-EHCR OFF" –> "Z-EHCR 1"...
Extended LCD screen:
1. Press the AUDIO button g to switch to AU-
DIO operating mode.
2. Press the JOYSTICK k upwards or down-
wards and select "Z-EHCR". Press the enter
button in the centre of the JOYSTICK to re-
call the sound processor menu.
3. Press the JOYSTICK upwards or downwards
to select between the following tone types.
"TYPE 1" (tone type 1)
"TYPE 2" (tone type 2)
"TYPE 3" (tone type 3)
"OFF" (sound processor off),
and then press the enter button in the
centre of the JOYSTICK to select the rel-
evant tone type.
4. After setting, press the JOYSTICK to the right
or left to recall "MENU". Subsequently, press
the enter button in the centre of the JOY-
STICK to switch to AUDIO operating mode.
Press the AUDIO button g to switch from AUDIO oper-
ating mode to STANDARD display.
Sound programming
Note:
• This function is only available with the unit ex-
tended.
1. Press the AUDIO button g to switch to AU-
DIO operating mode.
2. Press the JOYSTICK k upwards or down-
wards to select "Z-EH LVL". Press the enter
button in the centre of the JOYSTICK to re-
call the sound processor menu.
3. Press the JOYSTICK upwards or downwards
to select the level "Z-EN LVL" for the tone
type.
* If tone type 1 is set, the bass can be set within a range
of ±2.
* If tone type 2 is set, the treble can be set within a range
of ±2.
* If tone type 3 is set, the bass and treble can be set within
a range of ±2.
4. After setting, press the JOYSTICK to the right
or left to access "MENU". Subsequently,
press the enter button in the centre of the
JOYSTICK to switch to AUDIO operating
mode.
Basic operation
19