Installing The Main Unit - VDO MR6000 Owner's Manual And Mounting Instructions

5.

INSTALLING THE MAIN UNIT

Universal mounting frame
1. Insert the universal mounting frame into the
instrument panel, bend the individual sheet
metal tabs of the universal mounting frame
inwards using a screwdriver and secure as
shown in Figure 6.
2. Connect wiring as shown in Section 8.
3. Push the main unit into the universal moun-
ting frame until it engages.
4. Attach the outer decorative mouldings so
that all studs engage.
• Cut-out dimensions for console
182 mm
Cut-out
Screwdriver
Outer moulding
Installation aperture
Sheet metal tabs
Special screw
Main unit
2 springs
Note:
Insert the outer moulding so
that its metal component on
the back fits into the upper
edge of the main unit.
Figure 6
Note:
1) For certain vehicle types, special kits are
required for correct installation. Please
contact a VDO Dayton dealer for details.
2) Ensure that the front sheet metal tabs are
properly secured to prevent the main unit
from becoming loose.
Rear fastening bracket (on vehicle)
Instrumentpanel
Rubber
grommet
Universal mounting frame
Sheet metal tabs
41