Table of Contents
Advertisement
5
4
3
CHANGING
THE HEADLIGHT BULBS
Carefully read p. 82 (BULBS).
The headlight contains:
– one parking light bulb (1);
– one low/hight beam bulb (2).
To change the bulbs:
PARKING LIGHT BULB
♦
Remove the front inner shield, see p. 73
(REMOVING THE FRONT INNER
SHIELD).
CAUTION
While removing a bulb socket, do not
pull on the wires.
2
1
7
♦
Grasp the bulb socket (3), pull it and remove
it from its seat.
♦
Remove the parking light bulb (1) and
replace it with an identical bulb.
LOW/HIGH BEAM BULB
♦
Remove the front inner shield, see p. 73
(REMOVING THE FRONT INNER
SHIELD).
♦
Pull back the rubber boot (4) with your
fingers.
♦
Rotate the bulb socket (5) counterclockwise
and remove it.
♦
Push the bulb (2) toward the back of
thesocket
counterclockwise.
♦
Remove the bulb from the seat.
NOTE
Be sure to maintain the same
orientation as the old bulb when you install
the new bulb. Do not force the bulb, it will
go easily if it is properly oriented.
9
8
6
lightly,
and
rotate
it
CHANGING THE FRONT AND REAR
DIRECTION INDICATOR BULBS
Carefully read p. 82 (BULBS).
NOTE
Before changing a bulb, check
the fuse, see p. 79 (CHANGING FUSES).
♦
Place the vehicle on the center stand.
♦
Unscrew and remove the screw (6).
NOTE
While removing the lens, use extra
care to be sure that you do not break
the key.
♦
Remove the lens (7).
NOTE
Upon reassembly, position the
lens correctly in its seat.
CAUTION
Tighten the screw (6) moderately and
with care to avoid damaging the lens.
♦
Push the bulb (8) in slightly and rotate it
counterclockwise.
♦
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
carefully aligning the two bulb pins with
their guides in the socket.
♦
Correctly install a new bulb of the same type.
NOTE
If the bulb socket (9) has fallen
out of its seat, replace it correctly, ensuring
that the slot in the reflector aligns with the
screw hole in the body of the turn signal
lamp.
use and maintenance SR 50
83
Hide quick links:
Advertisement
Table of Contents
