INSTALLING THE REAR
MUDGUARD EXTENSION
Carefully read p. 55 (MAINTENANCE).
♦
Place the vehicle on the center stand.
WARNING
Before carring out the following opera-
tions, let the engine and the exhaust
silencer cool down until they reach room
temperature, in order to avoid burns.
72
use and maintenance SR 50
3
4
1
♦
Grasp the bulb socket (1), pull and take it
out of its seat.
♦
Release the license plate light cable (2)
from the two clips (3).
♦
Unscrew and remove the two nuts (4).
♦
Remove the license plate light (5).
♦
Unscrew and remove the nut (6).
♦
Withdraw the screw (7).
♦
Position the rear mudguard extension (8)
inside the number plate holder support (9).
♦
Position the license plate light (5) correctly
on the mudguard seat.
7
2
9
5
5
8
4
♦
Screw and tighten finger tight the two nuts
(4).
♦
Position the bulb socket (1) correctly in its
seat.
♦
Insert the license plate light cable (2) in the
two clips (3).
NOTE
We have not ever completly
tightened nut (6). It is only finger tightened
above.
♦
Insert the screw (7) and tighten finger tight
nut (6).
♦
Make sure that the rear mudguard
extension (8) is positioned correctly.
♦
Tighten the two nuts (4).
♦
Tighten the screw (7).
6
4