Table of Contents
Advertisement
LOW BEAM BULB
NOTE
Remove the bulb sockets one by
one in such a way as to avoid replacing
them incorrectly during reassembly.
If the bulb sockets must all be removed at
the same time, take great care to reas-
semble them in the proper position.
Working from the rear left side of the
front part of the fairing, pull back the rub-
ber boot (9) with your fingers.
Rotate the bulb socket (10) counter-
clockwise and remove it.
Push the bulb (11) toward the back of the
socket lightly, and rotate it counterclock-
wise.
Remove the bulb from the seat.
NOTE
Be sure to maintain the same ori-
entation as the old bulb when you install
the new bulb. Do not try to force the bulb,
it will go easily if it is properly oriented.
Carefully read p. 83 (BULBS).
NOTE
Before changing a bulb, check
the fuse, see p. 80 (CHANGING FUSES).
Position the motorcycle on the stand.
Unscrew and remove the screw (12).
NOTE
While removing the lens, use ex-
tra care to be sure that you do not break
the key.
Remove the lens (13).
NOTE
Upon reassembly, position the
lens correctly in its seat.
CAUTION
Tighten the screw (12) moderately and
with care to avoid damaging the lens.
Push the bulb (14) in slightly and rotate it
counterclockwise.
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
carefully aligning the two bulb pins with
their guides in the socket.
Correctly install a new bulb of the same
type.
NOTE
If the bulb socket (15) has fallen
out of its seat, replace it correctly, ensuring
that the slot in the reflector aligns with the
screw hole in the body of the turn signal
lamp.
use and maintenance RS 50
?
85
Hide quick links:
Advertisement
Table of Contents
