APRILIA RS 50 - 1999 Manual page 82

NOTE
The terms "right" and "left" are re-
ferred to the rider seated on the motorcycle
in the normal riding position.
It is possible to adjust the horizontal posi-
tion both to the right and to the left.
The adjustment is carried out using shims
and adjusting screws which are supplied
as a kit. They will be found in the glove
box/tool kit compartment.
?
82 use and maintenance RS 50
To adjust the beam:
Remove the front part of the fairing, see
p. 70 (REMOVING THE FRONT PART
OF THE FAIRING).
Unscrew and remove the screw (1).
Unscrew and remove the screws (2).
 
CAUTION
Handle with care.
Take care not to damage the electric
wires.
Loosen the headlight (3).
There are four groups of shims, for four dif-
ferent degrees of adjustment.
Each shim is marked with the type identifi-
cation code (for example: UPPER) and
with the group number (for example: 3°)
(see table below).
Adjustment degree
Gruop 1° 2°
Shim UPPER UPPER UPPER
1 2
Screw 4,2 x 20 4,2 x 20 4,2 x 20 4,2 x 20
LOWER LOWER LOWER
Shim
1 2
Screw 4,2 x 20 4,2 x 25 4,2 x 25 4,2 x 30
3° 4°
UPPER
3 4
LOWER
3 4