Table of Contents
Advertisement
Adjust the clutch if the clutch drags or slips
during operation.
A limited range of adjustment of the clutch
can be accomplished using the adjuster
(10) located at the left handlebar:
Pull back the rubber boot (11).
Loosen the lock nut (12).
Rotate the adjuster (10) until the free
play at the end of the clutch lever is be-
tween 0.39 – 0.59 in (10 – 15 mm) (see
figure).
Tighten the lock nut (12) to lock the ad-
juster in place.
Recheck the free play.
Reposition the rubber boot (11).
WARNING
If it is not possible to properly adjust
the clutch this way, see your Local
Delear.
NOTE
Inspect the clutch cable to make
sure that it is not damaged. The inner ca-
ble must have no broken strands, and the
outer cable must not be kinked or bent.
Periodically lubricate the clutch cable
with a suitable lubricant, see p. 93 (LU-
BRICANT CHART). This will protect it
from excessive wear and corrosion.
?
use and maintenance RS 50
41
Hide quick links:
Advertisement
Table of Contents
