Backup Remote Node Setup; Table 5-4 Advanced Wan Port Setup: Call Control Parameters - ZyXEL Communications ZYWALL 10W User Manual

ZyWALL 10~100 Series Internet Security Gateway
Table 5-3 Advanced WAN Port Setup: AT Commands Fields
FIELD
Called Id Enter the keyword preceding the dialed number.
Speed Enter the keyword preceding the connection speed.

Table 5-4 Advanced WAN Port Setup: Call Control Parameters

FIELD
Call Control
Dial Timeout (sec)
Retry Count
Retry Interval
(sec)
Drop Timeout
(sec)
Call Back Delay
(sec)
5.6

Backup Remote Node Setup

The rest of this chapter shows you how to configure a remote node for a dial-backup connection.
5.6.1 Metric
The metric sets the priority for the ZyWALL's routes to the Internet. If any two of the default routes have the
same metric, the ZyWALL uses the following pre-defined priorities:
1. Normal route: designated by the ISP (see Remote Node Setup chapter) or a static route (see the IP Static
Route Setup chapter)
2. Traffic-redirect route (see the Remote Node Setup chapter)
5-6
Enter a number of seconds for the ZyWALL to keep trying to set up
an outgoing call before timing out (stopping). The ZyWALL times
out and stops if it cannot set up an outgoing call within the timeout
value.
Enter a number of times for the ZyWALL to retry a busy or no-
answer phone number before blacklisting the number.
Enter a number of seconds for the ZyWALL to wait before trying
another call after a call has failed. This applies before a phone
number is blacklisted.
Enter a number of seconds for the ZyWALL to wait before dropping
the DTR signal if it does not receive a positive disconnect
confirmation.
Enter a number of seconds for the ZyWALL to wait between
dropping a callback request call and dialing the co-responding
callback call.
DESCRIPTION
DESCRIPTION
DEFAULT
CONNECT
DEFAULT
60 seconds
0 to disable
the blacklist
control
20 seconds
15 seconds
WAN and Dial Backup Setup
TO