My Wan Addr Sample Ip Addresses - ZyXEL Communications PRESTIGE 650H User Manual

Prestige 650 Series User's Guide
Table 19-2 Menu 11.3 Remote Node Network Layer Options
FIELD
Address When Full Feature is selected in the NAT field, configure address
Mapping Set mapping sets in menu 15.1. Select one of the NAT server sets (2-10) in
menu 15.2 (see the NAT chapter for details) and type that number here.
When SUA Only is selected in the NAT field, the SMT uses NAT server
set 1 in menu 15.2 (see the NAT chapter for details).
Metric The metric represents the "cost" of transmission for routing purposes. IP
routing uses hop count as the cost measurement, with a minimum of 1 for
directly connected networks. Type a number that approximates the cost for
this link. The number need not be precise, but it must be between 1 and
15. In practice, 2 or 3 is usually a good number.
Private This determines if the Prestige will include the route to this remote node in
its RIP broadcasts. If set to Yes, this route is kept private and not included
in RIP broadcast. If No, the route to this remote node will be propagated to
other hosts through RIP broadcasts.
RIP Press [SPACE BAR] and then [ENTER] to select the RIP Direction.
Direction Options are Both, In Only, Out Only or None.
Version Press [SPACE BAR] and then [ENTER] to select the RIP version. Options
are RIP-1, RIP-2B or RIP-2M.
IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and
Multicast
None disables IGMP.
IP Policies You can apply up to four IP Policy sets (from 12) by typing in their numbers
separated by commas. Configure the filter sets in menu 25 first (see the IP
Policy Routing chapter) and then apply them here.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

19.4.1 My WAN Addr Sample IP Addresses

The following figure uses sample IP addresses to help you understand the field of My Wan Addr in menu
11.3. Refer to the previous LAN and WAN IP Addresses figure in the web configurator chapter on LAN
setup for a brief review of what a WAN IP is. My WAN Addr indicates the local Prestige WAN IP
(172.16.0.1 in the following figure) while Rem IP Addr indicates the peer WAN IP (172.16.0.2 in the
following figure).
19-8
DESCRIPTION EXAMPLE
None
RIP-1
None
3, 4, 5, 6
Remote Node Configuration
2
2
No