Remote Management And Nat; System Timeout; Www; Figure 54 Remote Management: Www - ZyXEL Communications P-660R-D Series User Manual

P-660R-D Series User's Guide

9.1.2 Remote Management and NAT

When NAT is enabled:
• Use the ZyXEL Device's WAN IP address when configuring from the WAN.
• Use the ZyXEL Device's LAN IP address when configuring from the LAN.

9.1.3 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds).
The ZyXEL Device automatically logs you out if the management session remains idle for
longer than this timeout period. The management session does not time out when a statistics
screen is polling.

9.2 WWW

To change your ZyXEL Device's World Wide Web settings, click Advanced > Remote
MGMT to display the WWW screen.

Figure 54 Remote Management: WWW

The following table describes the labels in this screen.

Table 34 Remote Management: WWW

LABEL
Port
Access Status
101
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Chapter 9 Remote Management Configuration