Configuring Network Interfaces For Rip; Figure 3-130 Rip Network Addresses - SMC Networks SMC8748ML3 Management Manual

C
ONFIGURING THE
Command Attributes
Subnet Address – IP address of a network directly connected to this
router.
Web - Click Routing Protocol, RIP, Network Addresses. Add all interfaces
that will participate in RIP, and click Apply.
CLI - This example includes network interface 10.1.0.0 in the RIP routing
process.
Console(config)#router-rip
Console(config-router)#network 10.1.0.0
Console(config-router)#end
Console#show ip rip status
--------------- ------------ --------- --------------- --------------
10.1.0.253
10.1.1.253
Console#

Configuring Network Interfaces for RIP

For each interface that participates in the RIP routing process, you must
specify the protocol message type accepted (i.e., RIP version) and the
message type sent (i.e., RIP version or compatibility mode), the method for
preventing loopback of protocol messages, and whether or not
authentication is used (i.e., authentication only applies if RIPv2 messages
are being sent or received).
3-296
S
WITCH

Figure 3-130 RIP Network Addresses

Peer UpdateTime Version RcvBadPackets
0 0
0 0
4-325
4-327
4-336
RcvBadRoutes
73
66