Quality Of Service Commands - SMC Networks SMC8748ML3 Management Manual

C L
OMMAND INE
Example
Console#show map ip dscp ethernet 1/1
DSCP mapping status: disabled
Port
--------- ---- ---
Eth 1/ 1
Eth 1/ 1
Eth 1/ 1
Eth 1/ 1
. .
.
Eth 1/ 1
Eth 1/ 1
Eth 1/ 1
Console#
Related Commands
map ip dscp (Global Configuration) (4-279)
map ip dscp (Interface Configuration) (4-280)

Quality of Service Commands

The commands described in this section are used to configure Differentiated
Services (DiffServ) classification criteria and service policies. You can classify
traffic based on access lists, IP Precedence or DSCP values, or VLANs.
Using access lists allows you select traffic based on Layer 2, Layer 3, or Layer
4 information contained in each packet.
Command
class-map
match
policy-map
class
set
police
4-284
I
NTERFACE
DSCP COS
0 0
1 0
2 0
3 0
61 0
62 0
63 0
Table 4-72 Quality of Service Commands
Function
Creates a class map for a type of traffic
Defines the criteria used to classify traffic
Creates a policy map for multiple interfaces
Defines a traffic classification for the policy to
act on
Classifies IP traffic by setting a CoS, DSCP, or
IP-precedence value in a packet
Defines an enforcer for classified traffic
Mode Page
GC 4-286
CM 4-287
GC 4-289
PM 4-290
PM-C 4-291
PM-C 4-292