Rs-232 Controller Connection; Connecting 12-Volt Trigger Outputs To External Theater Equipment - Runco Video Xtreme VX-2ix Owner's Operating Manual

Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation
system (if present) to the RS-232 CONTROL port on the VX-2ix; see Figure 3-10.
For more information about using this connection, refer to Serial Communications on
page 51.
TRIGGERS
TRIGGERS
1 2
1 2
1
S-VIDEO 1
VIDEO COMPONENT
Pb Pr Y VIDEO
2
S-VIDEO 2
Pb Pr Y VIDEO
COMPONENT VIDEO
to Automation/
Control System
or PC
Figure 3-10. RS-232 Control System Connection
If your VX-2ix is equipped with a CineWide with AutoScope system, use the cable
supplied with the AutoScope Lens Motor to connect the motor to a 12-Volt trigger output
as shown in Figure 3-11.
Pb
to AutoScope
Lens Motor
Figure 3-11. Connecting the 12-Volt Trigger Output to the AutoScope Lens Motor
Runco VX-2ix Owner's Operating Manual
3 IR
3 IR
S-VIDEO
CONTROL
RS-232
S-VIDEO
RS-232
CONTROL
TRIGGERS
1 2 3
S-Video 1
Pr Y
Component Video Video S-Video 2 RS-232 Out
5 4 3 2 1
9 8 6
7
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
IR
RS-232 Control
3.5-mm
mini plug
25
Installation
RS-232 Controller
Connection
Connecting 12-Volt
Trigger Outputs to
External Theater
Equipment