Limiting The Banks That Can Be Switched (Bank Extent); Setting The Timing Used For Switching Patches (Bank Change Mode) - Roland GT-8 Owner's Manual

Chapter 7 Other Features
Limiting the Banks That Can
Be Switched (Bank Extent)
By setting an upper limit to the banks, thus limiting the range
of banks that can be switched, you can set the GT-8 so that
only the patches you need can be selected.
fig.07-161
1. Press [SYSTEM], then press PARAMETER [
[ ] so that "SYS: BANK Extent" is displayed.
fig.07-170d
2. Rotate the PATCH/VALUE dial to set the upper limit
for the banks.
Valid Settings: 1–85
3. Press [EXIT] to return to the Play screen.
72
1 2
3 1
]
Setting the Timing Used for Switching
Patches (Bank Change Mode)
This sets the timing with which the GT-8 switches to the next
patch when switching patches with the pedals.
fig.07-171
1. Press [SYSTEM], then press PARAMETER [
[ ] so that "SYS: Bnk Chg Mode" is displayed.
fig.07-180d
2. Rotate the PATCH/VALUE dial to set the timing for
switching patches.
Value Explanation
The patch switches instantly when a
Immediate BANK pedal or any of the number pedals
is pressed.
Although the indication in the display is
updated to reflect the change in the bank
Wait for a NUM.
when a BANK pedal is pressed, the patch
will not change until a number pedal has
been pressed.
3. Press [EXIT] to return to the Play screen.
1 2
3 1
]