Roland GT-8 Owner's Manual page 59

Even when using this procedure, the settings selected in
Step 6 are maintained as is and carried over to the next
effect.
8. Press [EXIT] to return to the Play screen.
9. To save the settings, use the Write procedure (p. 22).
Target
fig.05-110d
This sets the targeted operation. Possible assignments for the
target are as shown below.
Value Explanation
Effect On/Off, Effect's Parameters
Switches on/off the effect indicated in the screen and controls the ef-
fect's parameters.
MANUAL On/Off
Switches the MANUAL on and off.
TUNER On/Off
Switches the TUNER/BYPASS on and off.
Master BPM (TAP)
Used for tap input of the Master BPM.
Delay Time (TAP)
Used for tap input of the delay time.
MIDI Start/Stop
Controls the Start/Stop of external MIDI devices (such as sequencers).
MMC Play/Stop
Controls the Play/Stop of external MIDI devices (such as hard disk
recorders).
Patch Level Inc1
Increases the patch volume level by 10 units.
Patch Level Inc2
Increases the patch volume level by 20 units.
Patch Level Dec1
Decreases the patch volume level by 10 units.
Patch Level Dec2
Decreases the patch volume level by 20 units.
Hold Delay Stop
When "Hold" (p. 30) is selected for the DELAY type, the perfor-
mance is instantly stopped.
Patch Num. Inc
Switches to the next higher patch number in the same bank as the
currently selected patch.
Patch Num. Dec
Switches to the next lower patch number in the same bank as the cur-
rently selected patch.
Patch Bank Inc
Switches to the next higher bank number.
Patch Bank Dec
Switches to the next lower bank number.
* Although you can set this so that the same target is controlled
by more than one controller, in such cases, make sure not to
have different sources changing the parameter at the same
time. Changing the parameter simultaneously using different
sources may result in noise being generated.
Chapter 5 Using Pedals to Control the Effects
Target Range
fig.05-120d
The value of the parameter selected as the target changes
within the range defined by "Min" and "Max," as set on the
GT-8.
When using an external foot switch, or other controller that
acts as an on/off switch, "Min" is selected with Off
(CLOSED), and "Max" is selected with On (OPEN).
When using an external expression pedal or other controller
that generates a consecutive change in the value, the value of
the setting changes accordingly, within the range set by the
minimum and maximum values.
Also, when the target is of an on/off type, the median value
of the received data is used as the dividing line in
determining whether to switch it on or off.
When using the foot switch:
fig.05-130
maximum value
Target Max
minimum value
Target Min
When using the EXP pedal:
fig.05-140
maximum value
Target Max
minimum value
Target Min
When the pedal
is fully raised
Amount of change in
parameter value
Off On
Release Depress
Foot Switch
When the pedal
is fully advanced
EXP Pedal
59