Removing An Expansion Board; Configuring The Newly-Installed Expansion Board - Roland Fantom G8 User Manual

5.
Press firmly inward until the tabs on the instrument lock
into the holes of the expansion board.
6.
Use the screws that you removed in step 2 to fasten the
cover back in place.

Removing an Expansion Board

To remove an expansion board, reverse the process by which you
inserted it.
1.
Unlatch the Fantom-G's tabs.
2.
Slowly raise the expansion board upright.
3.
Pull out the expansion board by reversing step 3 of the
installation process.
4.
Attach the cover by reversing step 2 of the installation
process.
Installing the Expansion Board
Configuring the Newly-
installed Expansion Board
After you've finished installing an expansion board into the Fantom-
G, you must perform the following procedure.
You'll perform this procedure only once, the first time you turn
on the power after inserting an expansion board.
1.
Turn on the power as described in "Turning On the Power"
(p. 28).
2.
When the Fantom-G starts up, an install confirmation
screen for the newly inserted expansion board will appear.
Press [F8 (Execute)] to execute the install confirmation
process.
If you decide to cancel, press [F7 (Cancel)].
If the install confirmation screen does not appear when you
start up for the first time, it is possible that the expansion board
was not detected correctly. Reinstall the expansion board
correctly.
This process will require several minutes. Never turn off the
power until this process has been completed.
3.
When the screen indicates that installation has been
completed, turn the power off, and then on again.
This completes the installation process.
For details on using the expansion board, refer to the manual
included with the expansion board.
309