Roland Fantom G8 User Manual page 167

Roland fantom g8: user guide
Hide thumbs Also See for Fantom G8:
Table of Contents

Advertisement

20: SLICER
By applying successive cuts to the sound, this effect turns a
conventional sound into a sound that appears to be played as a
backing phrase. This is especially effective when applied to sustain-
type sounds.
fig.MFX-20
L in
Slicer
R in
Slicer
Parameter
Value
Description
Step 01–16
0–127
Level at each step
Rate #
0.05–10.00
Rate at which the 16-step sequence will
Hz, note
cycle
Attack #
0–127
Speed at which the level changes be-
tween steps
Input Sync
OFF, ON
Specifies whether an input note will
Sw
cause the sequence to resume from the
first step of the sequence (ON) or not
(OFF)
Input Sync
0–127
Volume at which an input note will be
Threshold
detected
Mode
LEGATO,
Sets the manner in which the volume
SLASH
changes as one step progresses to the
next.
Shuffle #
0–127
Timing of volume changes in levels for
even-numbered steps (step 2, step 4, step
6...).
Level
0–127
Output level
21: ROTARY
The Rotary effect simulates the sound of the rotary speakers often
used with the electric organs of the past. Since the movement of the
high range and low range rotors can be set independently, the
unique type of modulation characteristic of these speakers can be
simulated quite closely. This effect is most suitable for electric organ
Patches.
fig.MFX-21
L in
Rotary
R in
Parameter
Value
Speed #
SLOW, FAST
Woofer Slow
0.05–10.00 Hz
Speed
Woofer Fast
0.05–10.00 Hz
Speed
L out
R out
LEGATO: The change in volume from
one step's level to the next remains
unaltered. If the level of a following
step is the same as the one preceding
it, there is no change in volume.
SLASH: The level is momentarily set
to 0 before progressing to the level of
the next step. This change in volume
occurs even if the level of the follow-
ing step is the same as the preceding
step.
The higher the value, the later the beat
progresses.
L out
R out
Description
Simultaneously switch the rota-
tional speed of the low frequency
rotor and high frequency rotor.
SLOW: Slows down the rota-
tion to the Slow Rate.
FAST: Speeds up the rotation
to the Fast Rate.
Slow speed (SLOW) of the low
frequency rotor
Fast speed (FAST) of the low fre-
quency rotor
Parameter
Value
Woofer
0–15
Acceleration
Woofer Level
0–127
Tweeter Slow
0.05–10.00 Hz
Speed
Tweeter Fast
0.05–10.00 Hz
Speed
Tweeter
0–15
Acceleration
Tweeter Level
0–127
Separation
0–127
Level #
0–127
22: VK ROTARY
This type provides modified response for the rotary speaker, with
the low end boosted further.
This effect features the same specifications as the VK-7's built-in
rotary speaker.
fig.MFX-22
L in
Rotary
R in
Parameter
Value
Speed #
SLOW, FAST
Brake #
OFF, ON
Woofer Slow
0.05–10.00 Hz
Speed
Woofer Fast
0.05–10.00 Hz
Speed
Woofer Trans
0–127
Up
Woofer Trans
0–127
Down
Woofer Level
0–127
Tweeter Slow
0.05–10.00 Hz
Speed
Tweeter Fast
0.05–10.00 Hz
Speed
Tweeter Trans
0–127
Up
Tweeter Trans
0–127
Down
Tweeter Level
0–127
Spread
0–10
Low Gain
-15– +15 dB
High Gain
-15– +15 dB
Level #
0–127
Effects List
Description
Adjusts the time it takes the low
frequency rotor to reach the new-
ly selected speed when switch-
ing from fast to slow (or slow to
fast) speed. Lower values will re-
quire longer times.
Volume of the low frequency ro-
tor
Settings of the high frequency ro-
tor
The parameters are the same
as for the low frequency rotor
Spatial dispersion of the sound
Output Level
2-Band EQ
L out
R out
2-Band EQ
Description
Rotational speed of the rotat-
ing speaker
Switches the rotation of the
rotary speaker.
When this is turned on, the
rotation will gradually
stop. When it is turned off,
the rotation will gradually
resume.
Low-speed rotation speed of
the woofer
High-speed rotation speed of
the woofer
Adjusts the rate at which the
woofer rotation speeds up
when the rotation is switched
from Slow to Fast.
Adjusts the rate at which the
woofer rotation speeds up
when the rotation is switched
from Fast to Slow.
Volume of the woofer
Settings of the tweeter
The parameters are the
same as for the woofer.
Sets the rotary speaker stereo
image. The higher the value
set, the wider the sound is
spread out.
Gain of the low range
Gain of the high range
Output Level
167

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fantom g7Fantom g6

Table of Contents