System Settings (Settings Common To All Modes); How To Make System Function Settings; Saving The System Settings (System Write) - Roland Fantom G8 User Manual

System Settings (Settings Common to All Modes)

Settings that affect the entire operating environment of the Fantom-
G, such as tuning and MIDI message reception, are referred to as
system functions. This section explains how to make settings for
the System functions and describes the functions of the different
System parameters.
How to Make System
Function Settings
1.
Press [MENU] to open the Menu window.
2.
Turn the VALUE dial or use [CURSOR] to select "System,"
and then press [ENTER].
The System Setup screen appears.
fig.25-001_50
F-key operations in the System Setup screen
F-key Explanation
F1 Moves the edit group tab upward.
Group/Up
F2 Moves the edit group tab downward.
Group/Down
F3 Edits the system parameters.
Setup
F4 Displays system information.
Info
F5 Specifies the wallpaper.
Wallpaper
F6 Edits screen-related settings.
Appearance
F7 Saves system settings.
Sys Write
F8 Returns to the previous screen.
Exit
3.
The parameters are organized into several edit groups. Use
[F1 (Up)] [F2 (Down)] to switch tabs.
4.
Use [CURSOR] to move the cursor to the parameter you
wish to modify.
When the cursor is located at a parameter value, you can press
[ENTER] to access a window for setting the value.
• When all the parameters cannot be shown within a single settings
screen, a scroll bar will be displayed at the right side of the
screen. In such cases, press
5.
Turn the VALUE dial or press [INC] [DEC] to get the value
you want.
6.
Repeat steps 3–5 to set each System parameter you want to edit.
7.
To save the settings you modified, press [F7 (Sys Write)]
and perform the Write operation. If you do not want to save,
press [EXIT] to return to the previous screen.
290
Page
–
–
p. 291
p. 302
p. 303
p. 304
p. 290
–
to scroll the screen downward.
Saving the System Settings
(System Write)
Changes you make to the System function settings are only
temporary—they will be discarded as soon as the power is turned
off. If you want to keep any changes you've made in the system
settings, you must save them in internal system memory.
When you perform the save procedure, the data that previously
occupied the save destination will be lost. However, the factory
setting data can be recovered by performing the Factory Reset
procedure.
1.
Change the system function settings, and press [F7 (Sys
Write)].
fig.25-002_50
The display will indicate "System Write Completed!" The data
will be saved, and you're returned to the System Setup screen.