Basic Operation Of The Synth Part; The "Tones" That Change The Synth Tone; Selecting Wave Expansion Board Tones - Roland V-Combo VR-760 Owner's Manual

Performing with the Keyboard

Basic Operation of the Synth Part

fig.04-20a(SynthSction)

The "Tones" That Change the Synth Tone

You can switch the synth part to select the tone you prefer from 18 different
tones. You can select tones from six categories, each with three variations.
You can select the category by pressing either [STRINGS], [CHOIR/SCAT],
[BRASS], [SYNTH LEAD], [SYNTH PAD], or [BASS] buttons.
Press the [VARIATION] button to select the variation.
The [VARIATION] button's indicator changes each time the button is
pressed, cycling through "OFF," "red," and "green," indicating which
variation is currently selected.
fig.04-21(Tone Buttons)
Pressing a lit CATEGORY button causes the light to go off, and turns off the
synth's sound generator.

Selecting Wave Expansion Board Tones

If you have an SRX Wave Expansion Board installed, you can press the [SRX
EXPANSION] button to select global patches on the expansion board as
tones.
1.
Press the [-] or [+] button located above the
[SRX EXPANSION] button.
If you have two expansion boards installed, you can select from a single list
of global patches on the two boards.
46
For more on the synth
part's tones, refer to the
"Tone List" (p. 99).
By holding down either the
[-] or [+] button, and while
holding it down pressing
the other button, you can
have the values change
rapidly in the direction of
the button pressed first.