Table of Contents
Advertisement
9 Help
9.1 Error messages – Reports
If a problem occurs during fax transmission or reception, one of the following messages will be printed on
the confirmation and journal reports (page 31).
Message
COMMUNICATION ERROR
DOCUMENT JAMMED
ERROR-NOT YOUR UNIT
JUNK FAX PROH. REJECT
MEMORY FULL
NO DOCUMENT / FAILED PICKUP
OTHER FAX NOT RESPONDING
PRESSED THE STOP KEY
THE COVER WAS OPENED
OK
For assistance, please visit http://www.panasonic.com/consumersupport
Code
Cause & Solution
40-42
L A transmission or reception error occurred.
46-72
Try again or check with the other party.
FF
43
L A line problem occurred. Connect the
44
telephone line cord to a different jack and try
again.
L An overseas transmission error occurred. Try
using the overseas mode (feature #411, page
55).
-----
L The document is jammed. Remove the
jammed document (page 74).
54
L A transmission or reception error occurred
59
because of a problem with the other party's
70
fax machine. Check with the other party.
-----
L The junk fax prohibitor feature of this unit
rejected fax reception.
-----
L The memory is full of received documents
due to a lack of recording paper or a recording
paper jam. Install paper (page 17) or clear the
jammed paper (page 71).
-----
L The document was not fed into the unit
properly. Re-insert it and try again.
-----
L The other party's fax machine is busy or has
run out of recording paper. Try again.
L The other party's fax machine rings too many
times. Send the fax manually (page 30).
L The other party's machine is not a fax
machine. Check with the other party.
L The number you dialed is not in service.
-----
L {STOP} was pressed and fax communication
was canceled.
-----
L The front cover was opened. Close it and try
again.
-----
L Fax transmission or reception was
successful.
9. Help
59
Advertisement
Table of Contents
