Table of Contents
Advertisement
6
Press {STOP} to exit.
Note:
L Confirm the stored items by printing a
broadcast programming list (page 77).
4.4.2 Adding a new item into the
broadcast memory
After initial programming, you can add new items
(up to a combined total of 20).
1
Press {>}.
L Confirm that there are no documents in
the document entrance.
2
Press {A} or {B} repeatedly to display the
desired broadcast memory
("<BROADCAST1>", "<BROADCAST2>" or
"<MANUAL BROAD>").
3
Press {DIRECTORY PROGRAM}.
4
Press {*}.
5
Press {A} or {B} repeatedly to display the
desired item you want to add.
6
Press {SET}.
L To add other items, repeat steps 5 and 6
(up to 20 items).
7
Press {DIRECTORY PROGRAM} to exit.
Note:
L When adding new items to the MANUAL
BROADCAST memory, you can only select
stored items.
4.4.3 Erasing a stored item from
the broadcast memory
1
Press {>}.
L Confirm that there are no documents in
the document entrance.
2
Press {A} or {B} repeatedly to display the
desired broadcast memory
("<BROADCAST1>", "<BROADCAST2>" or
"<MANUAL BROAD>").
3
Press {DIRECTORY PROGRAM}.
4
Press {#}.
5
Press {A} or {B} repeatedly to display the
desired item you want to erase.
L To cancel erasing, press {STOP}.
6
Press {SET}.
7
Press {SET}.
L To erase other items, repeat steps 5 to 7.
8
Press {DIRECTORY PROGRAM} to exit.
4.4.4 Sending the same
document to pre-programmed
parties
1
Insert the document FACE DOWN.
2
If necessary, press {RESOLUTION}
repeatedly to select the desired resolution
(page 30).
3
Press the desired {BROADCAST} (1-2) or
{MANUAL BROAD}.
L The document will be fed into the unit and
scanned into memory. The unit will then
send the data to each party, calling each
number sequentially.
L After transmission, the stored document
will be erased from memory
automatically, and the unit will
automatically print a report (broadcast
sending report).
Note:
L If you select "FINE", "SUPER FINE" or
"PHOTO" resolution, the number of pages
that the unit can send will decrease.
L If the document exceeds the memory
capacity, sending will be canceled.
L If a party is busy or does not answer, it will be
skipped and redialed later 1 time.
To cancel broadcast transmission
1. Press {STOP} repeatedly until "SEND
CANCELED?" is displayed.
2. Press {SET}.
4. Fax
33
Advertisement
Table of Contents
