Liner/Batch Takeup Kit; Paper Cutter - Intermec EasyCoder PX4i User Manual

Liner/Batch Takeup Kit

Paper Cutter

EasyCoder PX4i Bar Code Label Printer User's Guide (Fingerprint Version)
This is a factory-installed option only and is used to separate
labels from the liner and wind up the spent liner inside the
printer's media compartment. Labels, tickets, tags, etc. can be
wound up inside the media compartment after printing by fitting
a special guide to the front of the print unit.
The kit consists of a stepper motor that drives the liner drive
roller in the print unit (fitted as standard) and a takeup hub in
the media compartment. A guide shaft is fitted to the center
section immediately behind the slack absorber. A guide plate is
fitted at the rear of the media compartment and can be used to
replace the standard tear bar on the print unit for batch takeup
operation.
Operation and media load are described in
Strip)" on page 34 and
on page 40.
The EasyCoder PX4i printer can easily be fitted with an optional
paper cutter. The cutter unit replaces the front door or the label
taken sensor (LTS), if one is equipped. It is connected by a single
cable to the DIN-connector on the printer's front. The paper
cutter is available both as a factory-installed option and as a
operator-installable kit.
The paper cutter increases the printer's total weight by
approximately 1.0 kg (2.2 lb) and its length by 28 mm (1.1 in).
The paper cutter is intended to cut through continuous non-
adhesive paper-based media or through the liner between labels.
It must not cut through any adhesive, which would stick to the
cutting parts and rapidly render the cutter inoperable–possibly
also causing damage to the electric motor. Maximum thickness
for normal paper-based materials is 175 μm (≈175 grams/m2).
The paper cutter can be tilted forward in order to facilitate
cleaning and media load. For media load instructions, see
"Cut-Off " on page 29."
The cutter is activated by CUT or CUT ON instructions, see the
Intermec Fingerprint v8.3x manuals.
Chapter 9 — Options
"Peel-Off (Self-
"Internal Batch Takeup (Roll-to-Roll)"
103