Intermec Ready-To-Work Indicator - Intermec EasyCoder PX4i User Manual

Chapter 10 — Troubleshooting

Intermec Ready-to-Work Indicator

Display Messages and LED Indications
Error/Event
Operational
Out of paper
Next label not found
Label not taken
Out of transfer ribbon
Head lifted
Cutter does not respond Blink
Cutter error1
Cutter error2
Cutter error3
Cutter open
LSS too high
108 EasyCoder PX4i Bar Code Label Printer User's Guide (Fingerprint Version)
The readiness of the printer, individually or as a part of a
solution, is indicated by the blue Intermec Ready-to-Work
indicator.
If the indicator blinks or is switched off, the printer is not ready.
Further information can be obtained in the display window by
pressing F5/i. In case of several errors or similar conditions
occurring simultaneously, only the most significant error is
displayed. Once this error has been cleared, next remaining error
is displayed.
The printer will also return error messages to the host, provided
there is a working two-way communication. Refer to the Intermec
Fingerprint v8.3x, Programmer's Reference Manual.
Provided the printer is connected to a network, all conditions
that prevents printing are reported to the EasyADC Console.
The EasyADC Console is a PC-based software which allows a
supervisor to monitor all connected devices that have an
Intermec Ready-to-Work indicator, including handheld
computers, access points, and printers.
.
Ready-to-Work Error Number Comment
On 0
Blink 1005
Blink 1031
Blink
Blink 1027
Blink 1022
1059
Blink 1701
Blink 1702
Blink 1703
Blink 1704
Blink 1007
No error