Setting Up The Printer - Intermec EasyCoder PX4i User Manual

EasyCoder PX4i Bar Code Label Printer User's Guide (Fingerprint Version)
6

Setting Up the Printer

This chapter describes the various parameters that are used
during Setup mode or in the various application programs to
configure the printer for the user's specific requirements. It covers
the following topics:
• Description
• Default Setup
• Setup parameters for communication, test/service, media, and
configuration.
When measurements are specified as "dots", the actual length in
millimeters or inches depends on the printhead density. Convert
as follows:
8 dots/mm (203 dots/inch) printhead:
1 dot = 0.125 mm = 0.0049 in (4.9 mils)
11.81 dots/mm (300 dots/inch) printhead:
1 dot = 0.085 mm = 0.0033 in (3.3 mils)
59