Switching On The Printer - Intermec EasyCoder PX4i User Manual

Chapter 3 — Starting Up

Switching On the Printer

20 EasyCoder PX4i Bar Code Label Printer User's Guide (Fingerprint Version)
Before switching on the printer, make the necessary connections,
and check that the printhead is engaged.
Switch on the power using the On/Off switch on the rear plate.
The "Power" LED on the front panel lights up when the power is
on. Wait for a few moments while the printer loads the program
and runs some self-diagnostic tests. The Display Window will
show the following progress indicator.
Starting
After a short time, the printer is initialized. The progress of the
initialization is indicated by an increasing number of colons on
the lower line in the display.
Initializing
:::
The type of startup file running in the printer is indicated by the
message shown in the display window immediately after
initialization.
A. Intermec Shell Startup Program
ENTER=SHELL
5 sec. v.8.1
4 sec.
3 sec.
Refer to "Intermec Shell Startup Program" on page 91
information on Intermec Shell. The digits in the lower right
corner of the display indicate the version of Intermec Shell.
v.8.1
v.8.1
2 sec. v.8.1
1 sec. v.8.1
for more