Advanced Remote Control Programming; Programming A Learned Button; Deleting A Single Learned Button - Insignia NS-42E859A11 User Manual

Notes on Z-Wave network management
• Adding a node or device can also be referred to as including a
node or device. Removing a node or device can also be
referred to as excluding or deleting a node or device.
• Every Z-Wave enabled device acts as a signal repeater and
multiple devices result in more possible transmission routes
which helps eliminate "RF dead-spots. "
Advanced remote control
programming

Programming a learned button

Your remote control includes a learning feature that lets you
add functions that are unique to your home entertainment
devices (such as VCR tracking up or down). However, there are
some considerations to keep in mind:
• Your original remote controls must be in working order for
learning to work correctly.
• Learned buttons are mode-specific, so each button can store a
unique function for each mode.
• Do not use the mode buttons or TiVo button.
• Certain device functions are not learnable, including
multi-frequency types, some high-frequency functions, and
other unusual formats.
• When setting up learned buttons, avoid high levels of
ambient light such as natural sunlight or energy efficient
fluorescent lights.
Note
Have your original remote controls handy before
programming learning.
To program a learned button:
Press and hold the A and D buttons at the same time until
1
the LED blinks twice, then release.
Enter 9 7 5. The LED blinks twice.
2
Notes
•
•
Press the mode button you want to learn functions on, then
3
press the button on the Insignia remote you want to
program.
Place your Insignia remote control head-to-head (about 2"
4
apart) from your original remote control (the one that came
with the device).
5 On the original remote, press and hold the button to be
learned. Continue holding the button on the original remote
until the Insignia's LED blinks twice.
Repeat Step 3 through 5 to program another button. After
6
you have completed programming all the buttons you want,
press and hold SELECT until the LED blinks twice to save all
data learned.

Deleting a single learned button

This process returns the button to its original programming for
the mode you select. You can also delete learned programming
by teaching a different function to the button (see
"Programming a learned button" on page 111).
Notes
•
•
To delete a single learned button:
1 Press and hold the A and D buttons at the same time until
the LED blinks twice, then release.
Enter 9 7 6. The LED blinks twice.
2
www.insigniaproducts.com
NS-32E859A11/NS-42E859A11
If more than 10 seconds pass between button
presses, the remote control exits programming.
If the LED displays one long flash instead,
replace the batteries. If the remote control
continues to display one long flash, the remote
control cannot learn a new button.
If more than 10 seconds pass between button
presses, the remote control exits programming.
If the LED displays one long flash instead,
replace the batteries. If the remote control
continues to display one long flash, the remote
control cannot learn a new button.
Appendix
111