Removing Your Remote Control From The Tv Z-Wave Network; Resetting Your Tv Z-Wave Network - Insignia NS-42E859A11 User Manual

Removing your remote control from the TV
Z-Wave network
To remove your remote control from the TV Z-Wave
network (TV as Primary Controller):
Press and hold VOL and CH on the front of your TV at
1
the same time. The Remove a Z-Wave Device screen opens.
Remove a Z-WAVE Device?
Go to your Z-Wave device and follow the instructions to
remove it from your Z-Wave network.
Press any button on the TV to cancel.
Press and hold and on the remote control for about five
2
seconds. The Z-Wave Device Removed screen opens. The
remote control is removed from the TV Z-Wave network, and
RF communication is not available. To close the screen, press
SELECT or wait a few seconds.
Note
• To enable RF communication, you have
to add the remote control to the Z-Wave
network again.
• To remove other Z-Wave devices from
your TV Z-Wave network, perform Step 1
above, then follow the instructions in
the user manual of that device to
complete the removal.

Resetting your TV Z-Wave network

To reset your TV Z-Wave network:
Press and hold VOL , VOL , and CH
1
your TV at the same time. The Reset Z-Wave Network? screen
opens.
Reset Z-Wave Network?
Warning: this will reset your Z-Wave network, and any
devices you wish to use will need to be added again.
Reset Z-Wave Network
Cancel
Press or
2
SELECT.
www.insigniaproducts.com
NS-32E859A11/NS-42E859A11
on the front of
to highlight Reset Z-Wave Network, then press
Appendix
109