HP Vectra VT6 User Manual page 97

What you should do:
61xx, 6500,
6510, 6520
1 Ensure the memory modules are installed correctly (refer to chapter 3).
8x06
2 If this does not fix the problem, initialize the system ROM (refer to "If You
3 If the problem persists, the system board may need to be replaced.
What you should do:
65xx, 66xx
1 Disable all shadowing with the Setup program.
2 If this fails to correct the problem, the system board may need to be
What you should do:
8060
1 Check that the hard disk drive has not been disabled with the Setup
2 Check that the disk power and data cables are correctly connected (refer
Explanation:
910B
1 You connected the flexible disk drive connector B to the disk drive, and
2 Change the flexible disk drive connector to A (refer to chapter 3).
4 Troubleshooting Your PC and Using the Setup Program
Can't Start the Setup Program" in this chapter on page 95).
Contact your service representative.
replaced. Contact your service representative.
program.
to chapter 3).
there is no connection to a drive A.
If Your PC Does Not Start
English 85