HP Vectra VT6 User Manual page 101

If You Cannot Use Any Video Resolution Higher Than 640
If you cannot select a video resolution higher than 640
should clear the contents of the CMOS memory.
To clear the configuration:
1 Switch off the PC and remove the cover (refer to chapter 3 for
instructions).
2 Set the system board switch 1 (CONFG) on the switch block to ON
to clear the configuration from the CMOS memory (refer to page 120
for the switch location).
3 Switch on the PC to erase the CMOS memory.
4 Check that error codes
Message Utility, and wait until the PC has started.
5 Switch off the PC.
6 Set the system board switch 1 (CONFG) on the switch block to OFF
to re-enable the configuration.
7 Replace the cover (refer to chapter 3).
8 Switch on the PC and run Setup by pressing
appears. (Error code
<Setup=F2>
starts.)
9 Press to save the configuration and exit from Setup.
4 Troubleshooting Your PC and Using the Setup Program
and are displayed by the Error
0240 0130
will appear when the PC
0130
If Your PC Has a Hardware Problem
480
480, you
when
English 89