HP Vectra VT6 User Manual page 117

Using the Start-Up
Center
Parallel Ports and
Serial Ports
NOTE
The Start-Up Center lets you choose which system devices the
computer can start (boot) from.
Start-Up Center
Control
Start from Flexible Disk
Start from Hard Disk
Bootable HDD Interface
Start from Network
Priority Selected
Priority of available devices . . 1
Some options will not be available if you selected
. . . Microsoft Windows NT
The
Priority Selected
be changed.
Use these options to select a combination of I/O address and IRQ
channel for the parallel port and for the serial ports.
To configure a parallel port mode, highlight
select ,
Centronics
Parallel Port . . . . . . . . . . . Parallel 1 (378h, IRQ7)
Parallel Port Mode
Serial Port A . . . . . . . . . . . Serial 1/2/3/4/Off
Serial Port B . . . . . . . . . . . Serial 1/2/3/4/Off
These options may not be available if Windows 95 is installed on your
computer.
4 Troubleshooting Your PC and Using the Setup Program
. . . Enabled/Disabled
. . . . . Enabled/Disabled
. . . . IDE
. . . . . . Enabled/Disabled
. . 2
. . 3
. . 4
, , or
OS/2
items are for information only and cannot
, or .
EPP ECP
. . . . . . . . Centronics/EPP/ECP
Using the HP Setup Program
Flexible Drive
IDE Hard Disk
IDE Hard Disk
Network
Operating System
.
Other
Parallel Port Mode
and
English 105