Installing An Operating System; Installing The Windows Nt Workstation Operating System - HP Vectra VT6 User Manual

Preparing to Install
Windows NT
Installation Procedure
NOTE
1 Setting Up Your PC

Installing an Operating System

Installing an Operating System
This section provides information on installing the Windows NT
Workstation operating system, OS/2 Warp Connect, and Windows 95 on
your HP Vectra. For detailed installation information, refer to the
manual that came with your operating system.

Installing the Windows NT Workstation Operating System

The following instructions describe a simple installation of the US
English version of the Windows NT Workstation operating system on a
Vectra PC with an IDE hard disk. For complete installation information,
consult the manual that came with the operating system.
1 Start your PC and press
2 Highlight
Operating System
key to save the setting and exit the Setup program.
Before installing Windows NT, make sure you have these disks:
Windows NT Setup disks
•
(Setup Boot disk, Setup disk #2, and Setup disk #3)
Windows NT CD-ROM
•
"XU/VT Drivers and Documentation" CD-ROM.
•
1 Insert the Windows NT "Setup Boot Disk" into drive
Windows NT CD-ROM in the CD-ROM drive. Restart your PC.
2 Insert "Setup Disk #2" when prompted by the installation program.
3 Press
4 Press
If you are installing the US English version of Windows NT with a
localized (non-US English) keyboard, you should choose the
. The Custom Setup gives the option of selecting a localized
Setup
keyboard.
12 English
to enter the Setup program.
and select
to setup Windows NT.
to select the
Express Setup
. Press the
Windows NT
and insert the
A
.
Custom