Completing the
Installation of an IDE
CD-ROM drive
Completing the
Installation of a Flexible
disk drive
10 Remove the plastic panel from the cover by pulling the panel from
the left and unhinging its right-hand side. Store the panel in a safe
place.
11 Install any other accessories before replacing the cover and
completing the installation.
1 Turn on the computer and press
2 In the
IDE Secondary Channel
make sure that the CD-ROM drive has been detected.
3 Press
to save and exit the program.
1 Turn on the computer and press
2 Check that the Setup program has detected the drive in the
Flexible Disk Drives
3 Press
to save and exit the program.
3 How to Install Accessories Inside Your PC
Unclip and lift out
the plastic panel
when
<Setup=F2>
section of the Setup program,
when
<Setup=F2>
section.
Installing Disk Drives
appears.
appears.
English
73