Compaq Evo N180 Maintenance And Service Manual page 95

1. Prepare the computer for disassembly (Section 5.3) and
remove the following components:
a. LED cover (Section 5.8)
b. Keyboard (Section 5.9)
c. Heat sink (Section 5.10)
2. Use a flat-bladed tool to turn the processor locking screw 1
one-half turn counterclockwise (Figure 5-17).
3. Lift the processor straight up and remove it 2.
Make sure the gold triangle 3 is in the upper right corner when
installing the processor.
Figure 5-17. Removing the Processor
Reverse the above procedure to install the processor.
Maintenance and Service Guide
Removal and Replacement Procedures
5–23