3. Remove the two PM2.0 × 5.5 screws 1 that secure the
expansion cover to the base enclosure (Figure 5-7).
4. Loosen the two Phillips screws 2 that secure the expansion
cover to the base enclosure.
These two screws are secured to the expansion cover by C clips
and should not be removed from the expansion cover.
5. Lift the left side of the expansion cover and swing it to the
right 3.
6. Remove the expansion cover 4.
The expansion cover is included in the Plastics Kit (spare part
number 253944-001).
Figure 5-7. Removing the Expansion Cover
Maintenance and Service Guide
Removal and Replacement Procedures
5–11