Compaq Evo N180 Maintenance And Service Manual page 110

Removal and Replacement Procedures
2. Disconnect the speaker cable 1 from the audio board.
3. Remove the two PM2.0 × 5.5 screws 2 securing the audio
board to the base enclosure (Figure 5-28).
4. Lift the back edge of the audio board 3 to disconnect it from
the system board.
5. Lift the audio board straight up 4 and remove it from the
base enclosure.
Figure 5-28. Removing the Audio Board
Reverse the above procedure to install the audio board.
5–38 Maintenance and Service Guide