Summary of Contents for Compaq Evo n1005v - Notebook PC
Page 1
Regulatory and Safety Notices Compaq Notebook Series Document Part Number: 289172-001 June 2002 This guide provides governmental agency information and electrostatic discharge guidelines.
Page 2
Compaq shall not be liable for technical or editorial errors or omissions contained herein. The information is provided “as is” without warranty of any kind and is subject to change without notice. The warranties for Compaq products are set forth in the express limited warranty statements accompanying such products.
Regulatory Notices This chapter provides country-specific regulatory notices and compliance information for your product. Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Compaq Computer Corporation may void the user’s authority to operate the equipment. Cables Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations.
If you have questions about your product that are not related to this declaration, write to: Compaq Computer Corporation P. O. Box 692000, Mail Stop 530113 Houston, TX 77269-2000 Or call Compaq at: Product Information Center 1-800-345-1518 Technical Support 1-800-OKCOMPAQ...
5 feet (1.5 m) and 6½ feet (2 m). If you have questions about the type of power cord to use, contact your Compaq authorized service provider. A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against it.
Do not attempt to recharge, disassemble, immerse in water, or dispose of it in fire. Replacement should be done by a Compaq authorized service provider using the Compaq spare part for this notebook.
Display Work Places in the Office Sector) when used in conjunction with docking bases, keyboards, and monitors that bear the “GS” approval mark. Compaq portable notebooks in a stand-alone mode are not intended for continuous use in an office environment.
Regulatory Notices Laser Safety All Compaq systems equipped with laser products comply with appropriate safety standards, including IEC 825. With specific regard to the laser, the equipment complies with laser product performance standards set by government agencies for Class 1 laser products.
Output Power: Less than 0.2mW or 10,869 W·m Polarization: Circular Numerical Aperture: 0.45 ± 0.04 Only authorized technicians trained by Compaq should attempt to repair this equipment. All troubleshooting and repair procedures are detailed to allow only subassembly/module level repair.
Regulatory Notices Modems Important Safety Instructions Å WARNING: When using this device, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: ■ Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool.
(as determined by the total RENs), contact the local telephone company. If this Compaq equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But, if advance notice is not practical, the telephone company will notify you as soon as possible.
Page 15
Regulatory Notices If you experience trouble with this Compaq equipment, call 1-800-OK-COMPAQ or 1-800-652-6672. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. You should only perform repairs to the equipment that are specifically discussed in the documentation included with the notebook.
Regulatory Notices Canadian Modem Regulatory Statements This equipment meets telecommunications network protective, operational, and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). This is confirmed by marking the equipment with the Industry Canada certification number. The Department does not guarantee that the equipment will operate to the user’s satisfaction.
Regulatory Notices New Zealand Modem Regulatory Statements The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.
Page 18
Regulatory Notices Some parameters required for compliance with Telecom’s Telepermit requirements are dependent on the equipment (PC) associated with this device. The associated equipment shall be set to operate within the following limits for compliance with Telecom’s Specifications: a. There shall be no more than 10 call attempts to the same number within any 30-minute period for any single manual call initiation.
Regulatory Notices Wireless Notices In some situations or environments, the use of wireless devices may be restricted by the proprietor of the building or responsible representatives of the organization. Such restrictions may apply when: ■ Using the wireless equipment on airplanes, or ■...
Regulatory Notices Canadian Regulatory Wireless Notice Operation is subject to the following two conditions: ■ This device may not cause harmful interference, and ■ This device must accept any interference received, including interference that may cause undesired operation. At the time of publication for this document, the following note applies to the operation of this product.
Regulatory Notices ■ ETS 300 328—Technical requirements for radio equipment ■ ETS 300 826—General EMC requirements for radio equipment This product may be used in all EU and EFTA countries unless the packaging indicates that it may not be used in France. Wireless Lan Bluetooth Japanese Notices...
Electrostatic Discharge A discharge of static electricity from fingers or other electrostatic conductors may damage electronic components. Before handling electrostatic-sensitive components, discharge static electricity by using one of the methods described in this chapter. Preventing Electrostatic Discharge Handling Drives ■ Before handling a drive, discharge static electricity by touching the unpainted metal surface or lug nuts on the connectors on the back of the notebook.
To provide proper ground, wear the strap snugly against the skin. ✎ If you need more information about static electricity or assistance with product installation, contact your Compaq authorized dealer, reseller, or service provider. 2–2 Regulatory and Safety Notices...