Removal and Replacement Procedures
6. Remove the hard drive by following these steps:
a. Remove the battery pack (Section 5.3).
b. Remove the optical drive.
c. Remove the two PM2.0 × 5.5 screws 1 that secure the
d. Slide the hard drive forward 2 to unseat the hard drive
e. Lift the front edge of the hard drive bracket 3 until it
Figure 5-5. Removing the Hard Drive
Reverse the above procedure to install the hard drive.
5–8
hard drive bracket to the base enclosure (Figure 5-5).
connector from the system board.
clears the base enclosure and slide the hard drive bracket
out of the hard drive bay.
Maintenance and Service Guide