Removal and Replacement Procedures
2. Remove the three PM2.0 × 5.5 screws 1 that secure the
charger board to the base enclosure (Figure 5-27).
3. Lift the back 2 and middle 3 of the board to disconnect it
from the system board.
4. Lift the board straight up and remove it from the base
enclosure 4.
5. Remove the shield 5.
The charger board shield is included in the Hardware Kit (spare
part number 253937-001).
Figure 5-27. Removing the Charger Board
Reverse the above procedure to install the charger board.
5–36
Maintenance and Service Guide