Table of Contents
Advertisement
Adjusting Upper
Blade Guide
The upper blade guide should be as close to the
workpiece as possible during cutting operations.
This will help ensure straight cuts by keeping the
blade from twisting and drifting off the cut line.
To adjust the upper blade guide, loosen the blade
guide knob (see Figure 39) and slide the upper
blade guide as close to the workpiece as possible,
then tighten the knob.
Blade Guide
Knob
Figure 50. Location of upper blade guide
components.
The lower blade guide has a wire brush that
makes contact with the blade to help clear away
chips and extend blade life (see Figure 51).
Blade Brush
Figure 51. Location of blade brush (lower rear
blade guard removed for clarity).
-36-
Upper
Blade Guide
Adjusting Work Stop
The Model G0592 is equipped with a work stop
for repetitive cutting operations. The work stop
can be installed on either side of the vise and
will need to be adjusted any time it is removed or
repositioned.
Adjusting Work Stop
Tool Needed
Hex Wrench 6mm .............................................. 1
To adjust work stop:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen work stop knob (see Figure 52), and
adjust work stop position in arm as needed
for workpiece, then tighten knob to secure.
3.
Loosen cap screw shown in Figure 52 to
adjust arm on rod until work stop contacts
workpiece, then tighten cap screw to secure.
Work Stop
Rod
Figure 52. Work stop assembly components.
Repositioning Work Stop
Tool Needed
Hex Wrench 4mm .............................................. 1
To reposition work stop:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen cap screw shown in Figure 53 to
remove arm from rod.
Model G0592 (Mfd. Since 01/23)
Qty
Arm
Qty
Advertisement
Table of Contents
