Table of Contents
Advertisement
2.2 SUPPLEMENTAL FLIGHT DATA
Pressing the DFLTS Softkey (a second-level PFD softkey) turns off metric Altimeter display, the Inset
NOTE:
Map, and wind data.
Some displayed information disappears when pitch exceeds +30˚/-20˚ or bank exceeds 65˚. The Altimeter and
Airspeed, Attitude, Vertical Speed, and Horizontal Situation indicators remain on the display and the Bearing
Information and Annunciation windows can be displayed during such situations. The following information
is removed from the PFD (and corresponding softkeys are disabled) when the aircraft experiences unusual
attitudes:
• Traffic Annunciations
• Inset Map
• Outside air temperature (OAT)
• DME Information Window
• Wind data
• Transponder Status Box
• System Time
• PFD Setup Menu
GENERIC TIMER
The PFD generic timer can be set to count up or down from a specified time (HH:MM:SS). When the
countdown on the timer reaches zero, the digits begin to count up from zero. If the timer is reset before
reaching zero on a countdown, the digits are reset to the initial value. If the timer is counting up when reset,
the digits are zeroed.
Setting the generic timer:
1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to select the time field (hh/mm/ss).
3) Use the FMS Knob to enter the desired time and press the ENT Key.
190-00692-00 Rev. B
• Windows displayed in the lower
right corner of the PFD:
– Timer/References
– Nearest Airports
– Flight Plan
– Alerts
– Procedures
– DME Tuning
Figure 2-30 Timer/References Window
Garmin G1000 Pilot's Guide for Piper PA32
FLIGHT INSTRUMENTS
• Minimum Descent Altitude/
Decision Height readout
• Glideslope, Glidepath, and
Vertical Deviation Indicators
• Altimeter Barometric Setting
• Selected Altitude
• VNAV Target Altitude
2-21
Advertisement
Table of Contents
