Table of Contents
Advertisement
ALT UNIT
STD BARO
OBS
CDI
DME
XPDR
STBY
ON
ALT
GND
VFR
CODE
IDENT
IDENT
TMR/REF
NRST
190-00692-00 Rev. B
Displays softkeys for setting the altimeter and BARO settings to metric units
METERS Displays altimeter in meters
Displays the BARO setting as inches of mercury
IN
HPA
Displays the BARO setting as hectopascals
Sets barometric pressure to 29.92 in Hg (1013 hPa if HPA softkey is
selected)
Selects OBS mode on the CDI when navigating by GPS (only available with
active leg)
Cycles through GPS, VOR1, and VOR2 navigation modes on the CDI
Displays the DME Tuning Window, allowing selection of the DME
Displays transponder mode selection softkeys
Selects standby mode (transponder does not reply to any interrogations)
Selects Mode A (transponder replies to interrogations)
Selects Mode C – altitude reporting mode (transponder replies to identification
and altitude interrogations)
Allows manual selection of ground mode in certain conditions
Automatically enters the VFR code (1200 in the U.S.A. only)
Displays transponder code selection softkeys 0-7
0 — 7
Use numbers to enter code
IDENT Activates the Special Position Identification (SPI) pulse for 18 seconds,
identifying the transponder return on the ATC screen
Removes numbers entered, one at a time
BKSP
Activates the Special Position Identification (SPI) pulse for 18 seconds,
identifying the transponder return on the ATC screen
Activates the Special Position Identification (SPI) pulse for 18 seconds,
identifying the transponder return on the ATC screen
Displays Timer/References Window
Displays Nearest Airports Window
VOR1
VOR2
GPS
Figure 1-14 Top Level PFD Softkeys
Garmin G1000 Pilot's Guide for Piper PA32
DME
SYSTEM OVERVIEW
ALERTS
1-19
Advertisement
Table of Contents
