Table of Contents
Advertisement
GPS NAVIGATION
OR:
1) Select the Nearest Airports Page.
2) Select the desired nearest airport.
3) Press the APR Softkey located at the bottom of the display. The LD APR (load approach) Softkey becomes
available.
4) Select the desired approach.
5) Press the LD APR Softkey. The Approach Loading Page is displayed with the transitions field highlighted.
6) Select the desired transition.
7) Press the ENT Key. The 'LOAD?' field is highlighted.
8) Press the ENT Key to load the approach. If navigating a flight plan previous to loading this approach, the G1000
will continue navigating the flight plan until the approach is activated.
9) Highlight the 'ACTIVATE' field.
10) Press the ENT Key to activate the approach and begin navigating to the IAP.
11) If the approach is not approved for GPS, a 'NOTAPPROVED FOR GPS' message is displayed with 'YES' highlighted.
Press the ENT Key to acknowledge the message (or select 'NO').
12) Press the ENT Key to return to the Approach Loading Page.
OR:
1) From any page, press the PROC Key. The Procedures Options Menu is displayed.
2) Highlight 'SELECT APPROACH'.
3) Press the ENT Key. The APPROACH window is displayed on the 'PROC – APPROACH LOADING' Page.
4) Select an approach.
5) Press the ENT Key. The TRANSITION window is displayed.
6) Select a transition (the 'VECTORS' option assumes vectors will be received to the final course segment of the
approach and will provide navigation guidance relative to the final approach course.)
7) Press the ENT Key.
8) Highlight 'LOAD?' or 'ACTIVATE?'. 'LOAD' adds the approach to the flight plan without immediately using the
approach for navigation guidance. This allows for the original flight plan to continue navigating until cleared
5-138
Figure 5-145 Not Approved for GPS Message
Garmin G1000 Pilot's Guide for Piper PA32
190-00692-00 Rev. B
Advertisement
Table of Contents
