Connecting The Ethernet Cable; Attaching The Power Supply; Replace The Lens Assembly - TRENDnet TV-IP300 User Manual

Connecting the Ethernet cable

Connect an Ethernet cable to the
network cable connector located
on the camera's rear panel, and
then attach it to the network.

Attaching the Power Supply

Attach the power supply's plug
to the cable of the lens ( ), and
then connect the cable's plug to
the power connector located on
the camera's rear panel labeled
DC 12V ( ). Then, connect
the power supply to the wall
outlet ( ).
TIP:
1. When you are connecting the camera, always connect the
Ethernet cable before connect the power supply.
2. You can confirm the power source is supplied from the
Power LED on the camera.
18

Replace the Lens Assembly

If required, you can replace the lens assembly with DC-Iris lens.
First, remove the original lens by turning it in an anti-clockwise
direction. (For detailed instructions, please refer to the section
Replacing the Lens of Appendix – Adjusting Camera Focus.)
1. Fit the additional lens onto the CS-mount ring and turn it in a
clockwise direction ( ).
2. Then, plug the cable to the camera's DC-Iris connector ( ).
TIP: When you replace a DC-Iris lens, you could adjust the
brightness of the video images using the Iris Level screw-knob.
19