Connect Ethernet Cable; Connect Power And Power On Camera - TRENDnet TV-IP600 User Manual

Connect Ethernet Cable

To connect the camera to your network, connect a
Category 5 or better Ethernet cable to the network
cable connector located on the camera's left side
panel, and then attach it to the network. The Ethernet
port will automatically detect and adjust to the speed
(10 or 100 Mbps) and polarity (MDI-II or MDI-X) of the
connection.

Connect Power and Power On Camera

To provide power to the camera, connect the AC power
adapter to the DC power input connector, also located
on the camera's left side panel, and then plug it to the
electrical outlet. As with any electrical device, make
sure the power source and camera are located in an
area where it is not going to get wet or present an
electrical hazard.
TV-IP600/W Wireless Network Camera
CAUTION: The Camera must be used with the power
adapter included with the device.
9