Table of Contents
Advertisement
TV-IP501P Internet Camera User Manual
Connect Ethernet Cable
To connect the camera to your network, connect a Category 5 or better Ethernet cable to the network
cable connector located on the camera's rear panel, and then attach it to the network. The Ethernet port
will automatically detect and adjust to the speed (10 or 100 Mbps) and polarity (MDI-II or MDI-X) of the
connection.
Connect Power Cable
To provide power to the camera using the Adapter, connect the AC power adapter to the DC power input
connector, also located on the camera's left side panel, and then plug it to the electrical outlet. As with
any electrical device, make sure the power source and camera are located in an area where it is not going
to get wet or present an electrical hazard.
Connect Power using Power over Ethernet (PoE)
The TV-IP501P camera can be powered up via its Ethernet connection using Power over Ethernet
technology. The diagram below shows you how to connect the TV-IP501P camera to a PoE enabled
switch. If the switch or router you are connecting the TV-IP501P camera to does not support PoE, a
power injector can be connected between the TV-IP501P Camera and the switch/router as shown in the
diagram below.
9
Advertisement
Table of Contents
