Table of Contents
Advertisement
To connect the camera to your network, connect a Category 5 or better Ethernet cable to the network
cable connector located on the camera's rear panel, and then attach it to the network. The Ethernet port
will automatically detect and adjust to the speed (10 or 100 Mbps) and polarity (MDI-II or MDI-X) of the
connection.
To provide power to the camera using the AC Adapter, connect the AC power adapter to the DC power
input connector, also located on the camera's left side panel, and then plug it to the electrical outlet. As
with any electrical device, make sure the power source and camera are located in an area where it is not
going to get wet or present an electrical hazard.
A manual reset can be conducted by following the procedure below. The reset button is located on the
rear panel of the camera. To reset the system settings to factory defaults, please follow these steps:
1.
Leave the camera powered on, do not disconnect the power.
2.
Use a paper clip or similar object to press the reset button and hold. See the Rear Panel picture
above to locate the reset button.
3.
Keep the button pressed about 5 seconds.
4.
Release the button.
The camera will then automatically reboot itself. Upon restarting the camera loads the factory default
configuration settings. The default IP address 192.168.10.30 and subnet mask 255.255.255.0 will be
applied unless a DHCP server is actively connected to the network. The administrator's default user
name is admin and the password is admin. Use the Setup Wizard shipped with the camera to reconfigure
it or access it through the web based management software.
TV-IP501W Internet Camera User Manual
Connect Ethernet Cable
Connect Power Cable
Reset Camera
10
Advertisement
Table of Contents
