Installing The Media Card Reader - Dell OptiPlex 755 User Manual

3 Remove the drive panel by sliding the drive release latch downward to open the panel, and then
remove it from the hinges.
4 Disconnect the cable from the back of the media card reader.
1
1 media card reader
5 Grasp the sliding plate lever and slide it towards the bottom of the computer until the drive panel
snaps open; while holding the lever in place, slide the media card reader out of the computer.

Installing the Media Card Reader

1 If you are replacing a media card reader, remove the shoulder screws from the existing drive and attach
the screws to the replacement media card reader.
NOTE:
If you are replacing an existing floppy drive with a media card reader, ensure you disable the floppy
before installing the media card reader. Boot your computer and enter system setup (see "Entering System
Setup" on page 280). Use the Diskette Drive option to disable the floppy drive. Follow instructions in
"Removing the Floppy Drive" on page 64.
2 If you are installing a new media card reader, remove the drive-panel insert for the 3.5-inch drive bay,
remove the shoulder screws from the inside of the drive-panel insert and attach the screws to the new
drive.
2
2 drive release latch
67
Drives