I Balance Wheel - Brother ULT-2003D Operation Manual

I Balance Wheel

1-4
"Needle Position" Button (Needle up / Needle down)
Use this button when changing sewing direction or for
detailed sewing in small areas. Press this button to raise or
lower the needle position. Press the button twice to sew a
single stitch.
"Reverse/Reinforcement Stitch" Button
Use this button to sew reinforcement stitches at the begin-
ning and end of sewing. Press this button, and the ma-
chine sews 3 stitches in the same spot and stops automati-
cally. For straight and zigzag stitch patterns that take re-
verse stitches, the machine will sew reverse stitches at low
speed only while holding down the "Reverse/Reinforce-
ment Stitch" button (the stitches are sewn in the opposite
direction from the main seam). (See page 2-3.)
"Start/Stop" Button
START
STOP
Press this button and the machine will sew a few stitches
at a slow speed, then begin sewing at the speed set by the
sewing speed controller. Press the button again to stop the
machine. Hold the button down to sew at the machine's
slowest speed. The button changes color according to the
machine's operation mode.
Green : the machine is ready to sew or is sewing.
Red : the machine can not sew.
Turn the balance wheel to raise or lower the needle. The
1
wheel should be turned toward the front of the machine.
1 Balance wheel
Setting Up
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
9 —